A quick guide to the process of painting your concrete floor

Garage and concrete floors can be seen well made and maintained by the painting. The material is this right for paint or epoxy coating. This can be difficult at times, but with the right technique, you can work easily.

Here's how to paint to paint the garage and concrete floor with epoxy:

· Cleaning complete.

Make sure you sweep or blow away any dust and dirt from the surface topainted. Just completely clean the environment of dirt, leaves, dust and other materials, the door could come from the garage at the base of your soil again.

After the sweep, must be to wash the entire surface coated with a pressure washer. Preferably used psi to that between 2500 and 3500. However, it is important to pay particular attention, since the water pressure may reduce the concrete. If you do not pressure washer, you can easily rent from rentalCenters.

For areas that are heavily greased and there are heavy arrears, a solution de-greaser can be applied to the surface. Scrub and completely after use with your pressure washer.

• Check your concrete floor.

It 'very important to check and monitor the area closely. In this way, you may be able to find any cracks, the places with low or high and other damage or defects on the surface. You must correct this if you want the bestResults.

For very fine cracks can be filled with epoxy coating and the bond. If you are large cracks but cracks appear jagged, or low, you must use the crack or patch kit filled with epoxy / concrete repair. It can also grind a real need. For low points in the concrete floor, epoxy compound patch can be applied and filling mixture on the surface.

· Etch the concrete floor.

AfterPressure washing, degreasing, if necessary, repairs and businesses in shock, you must hack the cement floor. This is necessary so that the epoxy floor coating to bond to the concrete floor below.

This mixture the same amount of hydrochloric acid and water, then distributing them across the surface of the concrete floor. Leave for 20 minutes after you are completely around the bottom withclear clean water until all acid has been washed away.

• You mix your color.

You may need to know how to mix epoxy. For a 2 - Pour mixture gallons of epoxy, the same amount of "Party A" and "Party B" to a clear 5-gallon plastic bucket. Use a Jiffy mixing paddle mixer or a drill at low speed of 2.1 mix. "Shake on the floor and raise the mixer paddle or never or outside, because air can move in the mixture Com. The mixture must be made only be threeto 3 ½ minutes, neither more nor less.

• To apply the epoxy paint

Start) Apply the paint from the farthest point from the door (s, with this one. You paint your way out of the brush to paint your garage for free, you go in wet paint and material movement and not to destroy . In applying the first coating, wet wet epoxy resin alone, the total area covered with rose. You have your paintingsmall portions so that the epoxy will not fade easily. Apply to the second layer, wait 2-3 hours until the first coat is already dry.

Since the right to work and suitable material garage floor can be used for your continued satisfaction.

cfmbathroomexhaustfan