Patch up your concrete floors

Not like the look of a floor with cracks and holes? Well, that's not exactly a fascinating spectacle. And the longer you look, the more angry. It might be time to repair his stick and patch the holes in the concrete. It is not your concrete floor patching difficult for the average person to do. She did not know of a professional, how to do it.

However, it is only in the wet jet holePlan. This is not enough to make a permanent repair, and a permanent repair is what we want. We need to know how to do the job properly. Otherwise we will end with a pathetic statement fixed the floor, with patches easily detached or seriously different from the rest of the surface.

During the preparation of the holes, we have to solve that part of the preparation of land, of which we need. Get a hammer and chisel and chip some of the concreteat the bottom of the hole is level. Then lay the sides come out a bit 'so that the patch did not draw it later. Then clean the area with water and wire brush. Get rid of all unnecessary particles and dirt into the hole.

The application of concrete mixture: After the hole is cleaned and prepared, apply a liquid adhesive cement with a brush. While the binder is still sticky to make the concrete mix (cement mixingwith water). Then apply the mixture of concrete into the hole. Be sure to hold the mixture is sent to every inch of the sides of the hole. Then proceed to fill the hole until it is completely covered.

Smoothing It Out: Do you have a board ready straight. Make sure there is at least one foot is longer than the width of the hole. Move the board back and forth to adjust the patch. When we used to launch the concrete mixture should be slightly mounded up there.And how does away with the card, press and compact the patch.

Since the patch dries slowly and feels firmer, smoother, there is then applied with a magnesium or wood. Move the spatula with a rocking motion on the floor with the edges of the patch. Do this over and over again as a dry mix. To further refine the patch using a steel spatula in the last two steps we take.

More tips: If the hole is about 1 inch of soil or deeper, weall we have to use a mixture of concrete with coarse, crushed stoned. For shallow holes, but we need a mixture of sand. The same procedures apply when you use them.

And that's it! All that's left to do, wait until the next day before walking on the patch. If you are repairing your garage or driveway, wait for about a week before driving the patch. We just need to follow three steps, the floor to fix a hole.

roomba vacuum eureka vacuum