To adjust the screed

Resilient flooring is smooth, it can easily meet the deficiencies in the background. E 'then the moisture is necessary to ensure that the correct input for the preparation to ensure a smooth surface. Concrete substrates must be protected. Resilient flooring can be installed under the concrete floor, or the grade or below or on the wood surfaces are on the ground that the individual is made of plywood panels or directly on an old one. Before beginning work on the basis ofLand preparation, new floors, the ground base and supporting structure must be secured is presented in good condition. And 'better, and to examine and repair minor problems in the early stages before they become problems. If you believe that the land base is in good condition, then you can continue to install the new floor to be sure of your business with a long life.

And 'necessary for the concrete slabdry, clean and level. You must ensure that the board is free to the end of dirt, moisture and fat old surface and the level of the disk when you install a new resilient floor of a concrete slab, the vote or less. You must ensure that the panel is dry, because if the humidity is still off the ground, even if the plans which will be solved eventually. Most of the floors of poured concrete, which are new, eventhose that are expressed on a dry barrier against moisture reduction of at least a month. If the heat and ventilate facilities on the ground right then accelerate the process of drying of the soil. But one of the drawbacks of the concrete floor is that it picks up moisture over a period of two years after installation. It would therefore be prudent to test the installation for the presence of moisture in the soil before you begin, you Process.

After securing the dryness of your concrete slab is checked for traces of oil, grease, old paint or the presence of other particles. To remove oil or grease stains with a cleaner garage floor that shops can be found at car accessory. Blobs or plaster or other material from the bottom of a spatula or a flat screwdriver tool can be useful for all zero a. To remove the old paint or old seals, you can use the sand> Plan. What do you soak or clean the floor. For the investigation of the low points on the surface with a ruler after cleaning the plate as much as possible. latex backing compound can be used to fill any cracks or bumps or joints, you can do so by following the manufacturer's instructions to be used for its intended use. The patch area must be dry-brushed with a stiff bristle brush or loose particles to be sucked or blown. This cleaning should be done after the connection is dry. There are two ways to solve the rugged terrain. The first way is to establish a new plywood sub-floor screeds. Another method is to pour old a new, thin concrete slab above.

The final step in the preparation of a concrete floor covering the surface with a vapor barrier or seal, which is the best for your situation? This may be suggested by the dealer floor.

bedskirt outlet mall