Attaching wood to concrete

A very important advice is to use the right tool for each method. If you are in the case of masonry and concrete, you are obviously facing a very hard material. wooden hammers are too light and too soft steel tip. Concrete is brittle. Hard cutting chips are expected to fly while working on it, so bear that always wear safety glasses to protect eyes.

Nails. Nail wood to concrete is likely to be directly as simple, fast and economicalMethod. Unfortunately, once activated, these nails may lose a pot a few hammer blows on the side of the border. So are better for the temporary location.

You can usually find two types of special nails at the hardware store, cut the nails and hardened concrete nails. Drive nails with a 2 - to 4-lb. Hammer. It's actually very difficult to drive nails concrete cured (hardened) with A-4 lbs. Hammer. They work best in practice, that only one of the few hardened Days.

Nails can be very effective in mortar joints, though. The mortar is softer than the concrete block or brick, and nails is good enough. For best results, turn right along the common border. And here's a professional tip: for better holding power, coated with an adhesive on the back of the wood before nailing it.

Pre-drilled for mounting. It 's family of fasteners that can be driven into a pilot hole. To resolve this wood not only> Concrete, but it is well fixed what else is on concrete.

You install, just drill the wood and concrete in the drive and the shutter.

The creation of the forum is the only tricky part. Use a carbide tip bit. Because these relatively small holes, your standard 1/4-inch or 8.3-inch drill, a suitable job is to do, although it may take several minutes each well bore. A hammer drill, but your question in a drill holeSeconds. A percussion drill is expensive, but can be rented. If you have a lot of holes to drill, they will be saving a lot of time.

It 's a good idea to glue your wood to concrete or masonry with this system, particularly if the screws. Once the screws are loose, do not shake shake.

Expansion fasteners. These closures are simple, effective and can be a heavy burden to bear. You can narrow should be shaken loose.

Because they require a greaterHole, you really need a hammer drill to drill the concrete. If you do not buy, rent or borrow, try drilling a 1 / 8 inch hole first with a little 'hard. Then use increasingly large carbide drills until you reach the right size.

Buy bolts, long enough to wedge into the concrete as thick as wood in depth. Drill another hole by 1 / 4 inch deep, as the screw moves back slightly while tightening.

Fermi. These are extremely fast, powerful anddangerous. They are mostly professional tools that every homeowner should be clear from the untrained to draw them fully understand the safety precautions. With stops, you can quickly nail surface in almost any concrete or masonry. Both the air and power systems operated hard-drive nails through the wood and solid in practice to a single shot. Flying metal, wood or concrete are certain hazards, eye protection is so important.

Bonding. AboutOver the past decade, construction adhesives are improved and more specialized. You can glue anything to buy on the wall. From laminated wood must be kept securely in place until the glue sets, it is practical, an adhesive with a different mounting system for mutual gain, the glue absorbs vibrations and shocks that could weaken the fasteners, and closures keep the wood firmly until the glue in September

proper preparation ensures a good adhesion. Make sure that the woodand concrete surfaces clean and dry. Loose paint, crayons or surface moisture caused to release the lien. When working with a very rough surface, a large bead to fill important gaps between the concrete and wood.

auraessentialoilshop Log Cabin Home barstoolshome